Quality Heat Pump Service in Hillsborough

Quality Heat Pump Repair and Replacement in Hillsborough

Not only can an electric heat pump raise the temperature in your home in Hillsborough, it can cool it too. When compared to traditional heating systems—like a gas furnace—you’ll also likely have a decreased energy bill.

Heat pumps work with an air handler, which circulates air throughout your home. While an air handler might resemble a furnace, it doesn’t produce heat through fuel combustion. However, some air handler models may have secondary electric heating or cooling parts to back up the heat pump.

When you need heat pump service or heat pump repair, call Fras-Air/General Service Experts Heating & Air Conditioning. We can repair any type of heat pump. Our technicians are NATE-certified, which means they are among the finest in the HVAC industry when it comes to heating and cooling.

And like all our other work, our services for heat pump systems are backed by a one-year 100% Satisfaction Guarantee.*

Schedule an appointment
Poor Maintenance Can Cost You
A badly maintained system can cost you. On average, an ignored heat pump can eat up 10 to 25 percent more energy, according to the U.S. Department of Energy. It’s also more likely to malfunction or not last as long.

When your HVAC system isn’t providing the best home heating or isn’t working correctly, try our troubleshooting list below.

No heat. Check your thermostat is set to “on” and “heat.” Next, make sure a circuit breaker hasn’t tripped. Recently installed a new thermostat? Make sure it’s a model made for heat pumps and wired properly.

Insufficient heat. Clogged filters, fan and coils can reduce airflow and wreck your system. Change your filter once a month, clean the unit’s coils and fan, and remove yard debris that may have built up around it. Your system may also have blocked air ducts, faulty valves or poor refrigeration flow.

Cold air instead of heat. Air from a heat pump won’t be as toasty as a forced air furnace. But if the air still seems too crisp, set the thermostat to emergency heat and at least 5 degrees above the inside temperature. If you get warm air, there may be trouble with your outdoor unit. Cold air means there’s possibly an issue with your thermostat or air handler. Your system may have also gone into defrost mode to prevent freezing. If you see frost or ice on the outdoor coil, your unit may have a defective defroster timer or control module, or it could be low on refrigerant.

Heat pump turns on and off frequently. Swap out your air filter and then monitor your thermostat, because it may need to be reset or need new batteries. If it’s cold and your system is working all the time, the thermostat may be set too high. Also, some heat pumps have trouble heating around 25 to 30 degrees Fahrenheit.

Rattling, grinding or squealing noises. If you hear rattling, try tightening the cover panels. If you hear grinding or squealing, stop using your system and call Fras-Air/General Service Experts Heating & Air Conditioning. This could indicate a serious problem.

Still having trouble with your heat pump? Fras-Air/General Service Experts Heating & Air Conditioning can help. Once we have your heat pump working, consider joining our routine maintenance plan that may help you avoid costly repairs afterward. Routine service may also increase your unit’s energy efficiency.
Should I Repair or Replace My Heat Pump?
When you’re faced with an expensive repair for your heat pump, it may be time to get a new one.

Your unit may need to be replaced when it:

Isn’t providing even heating and cooling

Needs constant repairs

Is increasing utility bills, even though you haven’t adjusted thermostat settings

Is more than 10 years old

When it comes to heat pump replacement or heat pump installation, Fras-Air/General Service Experts Heating & Air Conditioning can help you find and install an energy-efficient model that’s [[right for your home. We can also help decide whether your air handler needs to be replaced too.

You can count on a neat installation and an in-depth system check before we leave. This makes sure your new system is working properly and that you know how to use it.