Hassle-Free Boiler Repair and Replacement in Hillsborough

Here are some regular problems you might encounter with hot water and steam boilers. While you may be able to fix a few of these issues yourself, you may need a professional from Fras-Air/General Service Experts for more complicated heat repair or a nasty boiler breakdown.

• Thermostat isn’t accurate. Check that it’s switched to “on” and the right settings. Otherwise, your thermostat may need to be replaced.
• No heat. Broken parts, thermostat issues or inadequate water levels could be to blame.
• Leaking or dripping. Often caused by a broken internal part, worn-out seal or deterioration.
• Banging, whistling or gurgling sounds. Air in the system, low water pressure or imminent part failure can cause these noises.
• Rumbling or kettling noise. Restricted water flow because of lime and sludge accumulation in the heat exchanger. This causes water to overheat and boil.
• Pilot light is out. Caused by a worn-out thermocouple, draft or built-up deposit. Natural gas could also be turned off.
• Pressure is too low. Water could be leaking, or a pressure valve may need to be changed. Can also be caused by radiators that have been bled recently.
• Condensate pipe is frozen. This pipe runs outside, so there is a risk of freezing. Thaw it by pouring warm water over it.
• Radiators aren’t getting hot. Caused by sludge or air buildup in the system.
• Boiler keeps turning itself off. Could be caused by a number of issues: low water pressure, thermostat issue, closed valve causing low water flow, air or pump not circulating water properly.

A lack of routine tune-ups can often lead to boiler breakdowns. Fras-Air/General Service Experts can suggest a plan that could help you avoid costly repairs—and may enhance your equipment’s efficiency.